Configure Task And Voiceconsole; Touchconnect - Honeywell A700 Hardware Reference Manual

IMPORTANT
The bar code may be different from the one included in earlier versions of
VoiceCatalyst 4.x Release Notes.
For an 8680i running firmware version EE000071BAC or greater - this bar code
l
is required.
For an 8680i running earlier versions of the firmware - this bar code is
l
recommended although the bar code provided in earlier versions of the release
notes does work with these earlier firmware versions.
3. Scan the bar code to add a carriage return and line feed as termination characters.
4. For scan-based pairing, create a pairing bar code for each device. The bar code begins with
{FNC3}LnkB followed by the 12-digit Bluetooth MAC address for the device:
Additional information:
The 8680i User Guide contains bar codes to set other combinations of termination
l
characters. To add a different termination suffix, scan the SUFBK2 (Add Suffix) bar code,
then scan the bar codes for the desired suffix.
Use the Bluetooth Disconnect bar code to unlink the 8680i from the device.
l

Configure task and VoiceConsole

1. Set the following advanced parameter in Task config
barcodeport = bt_scan
2. Turn on Bluetooth on the device.
3. View the properties of the device and ensure Bluetooth is enabled. If it is not enabled, click
Edit this device and set Bluetooth Enabled to "enabled".
4. Select Pair this device with a peripheral.
5. For Pairing type select "Bluetooth Scanner".
6. For Connection Mode select "Device listens for peripheral connection".
7. Set Security to "Enabled" or "Disabled" as desired.
8. Scan the LnkB bar code created above to initiate pairing.
9. On the 8680i, observe the Bluetooth symbol in the user window status screen. The symbol
will change from cross out or flashing to continuously lit when the 8680i is paired with the
host device.

TouchConnect

CAUTION
During the NFC pairing process, the device is discoverable as a Bluetooth device.
171 Voice Device and Headset Hardware Reference Guide