Touchconfig: Bringing Additional A700/A700X Devices Online - Honeywell A700 Hardware Reference Manual

TIP
If the LEDs indicate that there is a problem, refer to information on troubleshooting to solve
the problem. See also
TouchConfig: Bringing Additional A700/A700x
Devices Online
Prerequisite: A single device has been configured. The following instructions are for configuring
additional devices.
IMPORTANT
TouchConfig can only be used with similar devices. An A700x can TouchConfig other A700x
devices but cannot TouchConfig A700 devices. Similarly, an A700 device can only
TouchConfig other A700 devices.
NOTE
TouchConfig uses near field communication (NFC). Data sent through NFC is not encrypted
nor does it follow any specific safety protocol. This is because the transfer occurs over such a
short range that it is nearly impossible for data to be intercepted.
1. Ensure that all devices are off.
2. On the configured device, press and hold the Plus (+) button then press the Play/Pause
button to put the device into sender mode.
The ring's small segment will be solid yellow and the NFC indicator will blink yellow.
3. On the unconfigured devices, press and hold the Minus (-) button then press the
Play/Pause button to put the devices into receiver mode.
The ring's large segment will be solid yellow and the NFC indicator will blink yellow.
4. Turn each of the unconfigured devices so that the sides with the
5. Hold the configured device so that the side of the device that has the
down. Align the raised oval on the device with the raised oval on an unconfigured device.
Ensure that the ovals are fully aligned, then hold the two devices steadily against each
11
Troubleshooting Problems Indicated by LED.
Voice Device and Headset Hardware Reference Guide
symbol are facing up.
symbol is facing