Configure Task And Voiceconsole; 8670 Scanner As Initiator - Honeywell A700 Hardware Reference Manual

Configure task and VoiceConsole

1. Set the following advanced parameter in Task config
barcodeport = bt_scan
2. Turn on Bluetooth on the device.
3. View the properties of the device and ensure Bluetooth is enabled. If it is not enabled, click
Edit this device and set Bluetooth Enabled to "enabled".
4. Select Pair this device with a peripheral.
5. For Pairing type select "Bluetooth Scanner".
6. For Connection Mode select "Device initiates connection with peripheral".
7. In the Bluetooth Address field enter the Bluetooth MAC address of the scanner. This 12-
character ID is labeled "MAC ID" and is found on the side of the battery unit of the scanner.
8. Set Security to "Enabled" or "Disabled" as desired.
9. Click Pair with peripheral to initiate pairing.

8670 Scanner as Initiator

The 8670 scanner must be set to Scanner Reconnect Mode (the scanner will continuously
l
attempt to connect to the device, and if disconnected the scanner will manage the
reconnection).
1. Restore factory defaults by scanning the Remove Custom Defaults and Activate Defaults bar
codes.
2. Scan the Scanner Reconnect Mode bar code.
3. Scan the bar code to add a carriage return and line feed as termination characters.
4. For scan-based pairing, create a pairing bar code for each device. The bar code begins with
{FNC3}LnkB followed by the 12-digit Bluetooth MAC address for the device:
Additional information:
The 8670 User Guide contains bar codes to set other combinations of termination
l
characters. To add a different termination suffix, scan the SUFBK2 (Add Suffix) bar code,
then scan the bar codes for the desired suffix.
Use the Bluetooth Disconnect bar code to unlink the scanner from the device.
l
Voice Device and Headset Hardware Reference Guide 174