Ean / Upc - Honeywell A700 Hardware Reference Manual

Registry Key
Code11CodeMark
Code11CheckDigitVerification
Code11BarCodeLengthL1
Code11BarCodeLengthL2
Code11BarCodeLengthL3
Code11BarCodeLengthMode
Code11CheckDigitTransmission
Code11UDSI

EAN / UPC

Support for the parameters in the table is labeled as follows:
ü = Parameter is supported and available via the Scanner Options tab in the device profile.
X = Parameter is not supported on this device.
NYI = Not Yet Implemented. These parameters should be considered unsupported, though
they can (with knowledge) be set via the CCI or advanced settings.
IMPORTANT
A730 and A730x support for symbologies and parameters may differ. Refer to the table
below for details.
The registry keys in the table below are located under:
[HKEY_LOCAL_MACHINE\Software\Vocollect\Imager\EAN / UPC]
Registry Key
UPC-AActivation
Voice Device and Headset Hardware Reference Guide
Default
A730
Value
0x2a
ü
0x1
ü
0x4
ü
0x0
ü
0x0
ü
0x0
ü
0x1
ü
C1
ü
Default
A730
Value
0x1
ü
A730x Description
A single character inserted before the
bar code data to indicate the
ü
symbology.
Number of check digits to verify.
ü
Range is 1 to 2.
Length value L1. Range is 0x0 to 0xFF
ü
(0 to 255).
Length value L2. Range is 0x0 to 0xFF
ü
(0 to 255).
Length value L3. Range is 0x0 to 0xFF
ü
(0 to 255).
Length verification mode, where
0 = "L1 is min length",
1 = "L1, L2, L3 are fixed lengths", – Not
ü
supported on N6600
2 = "L1 is min, L2 is max length".
Enable transmission of the check digit.
ü
User-defined symbology identifier.
ü
Range is 0-4 characters.
A730x Description
Enables the UPC-A symbology.
ü
52