Configure Task And Voiceconsole; 8680I As Initiator - Honeywell A700 Hardware Reference Manual

1. Restore factory defaults by scanning the Remove Custom Defaults and Activate Defaults bar
codes.
2. Scan the Host Reconnect Mode bar code.
3. Scan the bar code to add a carriage return and line feed as termination characters.
Additional information:
The 8680i User Guide contains bar codes to set other combinations of termination
l
characters. To add a different termination suffix, scan the SUFBK2 (Add Suffix) bar code,
then scan the bar codes for the desired suffix.

Configure task and VoiceConsole

1. Set the following advanced parameter in Task config
barcodeport = bt_scan
2. Turn on Bluetooth on the device.
3. View the properties of the device and ensure Bluetooth is enabled. If it is not enabled, click
Edit this device and set Bluetooth Enabled to "enabled".
4. Select Pair this device with a peripheral.
5. For Pairing type select "Bluetooth Scanner".
6. For Connection Mode select "Device initiates connection with peripheral".
7. In the Bluetooth Address field enter the Bluetooth MAC address of the 8680i. This 12-
character ID is labeled "MAC ID" and is found on the side of the battery unit of the 8680i.
8. For Security select "Enabled" or "Disabled" as desired.
9. If security is enabled, enter "0000" for Security Key.
10. Click Pair with peripheral to initiate pairing.

8680i as Initiator

The 8680i must be set to Scanner Reconnect Mode (the 8680i will continuously attempt to
l
connect to the device host, and if disconnected the 8680i will manage the reconnection).
1. Restore factory defaults by scanning the Remove Custom Defaults and Activate Defaults bar
codes.
2. Scan the Scanner Reconnect Mode bar code.
Voice Device and Headset Hardware Reference Guide 170