Using The Srx2/Srx3 Headset; Attaching The Srx2/Srx3 Electronic Module To A Headband; Srx3 Flip-To-Mute Feature - Honeywell A700 Hardware Reference Manual

4. Gently pull a new foam earpad around the plate.
5. Align the inside posts of the two sections of the earcup.
6. Push sections together until they click into place.

Using The SRX2/SRX3 Headset

Attaching the SRX2/SRX3 Electronic Module to a
Headband
1. Position the SRX2 electronic module with the button controls facing away from the
headband.
2. Insert the speaker on the back of the electronic module into the pocket on the earpiece
hub by aligning the notches on the speaker and hub pocket.
3. Push the electronic module into the hub pocket until it is firmly seated.

SRX3 Flip-To-Mute Feature

NOTE
This feature requires VoiceCatalyst 4.2 or greater (A700x).
This feature requires VoiceCatalyst 2.5 or greater (A700).
The SRX3 Headset has a flip-to-mute feature.
When the microphone boom is down (i.e., horizontal, at mouth level), the microphone is
l
active.
When the microphone boom is up (i.e., vertical) the microphone is muted.
l
In most cases, moving the microphone from horizontal to vertical functions the same as
l
pressing the play/pause button on the device to pause the device.
In most cases, moving the microphone from vertical to horizontal functions the same as
l
pressing the play/pause button on the device to start or resume play.
119 Voice Device and Headset Hardware Reference Guide