Manual Pairing With A700/A700X - Honeywell A700 Hardware Reference Manual

IMPORTANT
An unpaired device will constantly search for wireless headsets while in auto pairing mode.
Do not leave an auto pair-enabled device unpaired and powered on because the search will
drain the battery.
1. Reboot the Talkman device or remove it from a charger to initiate a scan for headsets.
2. Turn on the headset.
The headset will remain in pairing mode for ten minutes. If not paired within ten minutes, it
powers off.
3. Hold the headset and Talkman device so they are within six inches of each other but not
touching.
The blue LED indicator on the Talkman device turns on, may flash a few times, and then
remains lit. After 20 to 30 seconds, the headset beeps three ascending tones and its LED
indicator flashes blue. These indicators confirm that a pairing has completed.
4. Put on the headset. You will hear the headset repeat the serial number of the Talkman
device to which it is paired.
5. Verify that the number matches the serial number on the Talkman device.
If you need to attempt the pairing again, re-enter pairing mode by pressing and releasing
the Plus (+) and Minus (-) buttons on the headset control panel.
6. Press the Play/Pause button on the Talkman device to confirm the number.
7. Press the Play/Pause button again to begin working.

Manual Pairing with A700/A700x

Prerequisites:
The headset is powered off.
l
The Talkman device is not in a charger, and there is no wired headset connected to it.
l
The Talkman device is in sleep mode — not in use running a task or voice application. Its
l
green LED indicator is flashing. If the LED is solid green, press the Play/Pause button.
The Talkman device is Bluetooth ready with Bluetooth connection features enabled.
l
1. Turn on the headset.
The LED indicator is solid green. The headset remains in pairing mode for ten minutes then
powers off.
2. Press and hold the Plus (+) and Minus (-) buttons on the Talkman device for two seconds to
manually initiate a search for wireless headsets.
3. Immediately hold the headset and device so they are within six inches of each other but not
touching.
The blue LED indicator on the Talkman device turns on, may flash a few times, and then
remains lit. After 20 to 30 seconds, the headset beeps three ascending tones and its LED
indicator flashes blue. These indicators confirm that a pairing has completed.
4. Put on the headset. You will hear the headset repeat the serial number of the Talkman
device to which it is paired.
Voice Device and Headset Hardware Reference Guide 130