Configure Task And Voiceconsole - Honeywell A700 Hardware Reference Manual

c. Insert the battery into the scanner while continuing to hold the Restore key.
d. After approximately 5 seconds a chirp is heard and the scan LEDs flash green. This
signals the RS5100 is set to the default factory configuration.
3. Connect the RS5100 scanner to the PC with 123Scan installed using the USB cable.
4. Start the 123Scan utility.
a. Select Create new configuration file.
b. Select My scanner is connected via USB cable.
c. Select your scanner from the list.
d. Provide a name for the configuration file.
e. Click on Modify Data.
f. Select Append an enter key.
g. Click Done and Load to scanner.
5. Scan the SSP Bluetooth Classic Bar Code.
6. Remove and reinstall the RS5100 battery.
7. The scanner reboots and is discoverable as a Bluetooth device.
8. Open the PC Tool application.
9. Click the Show Bluetooth Address barcode button.
10. Enter the Bluetooth address of the RS5100 scanner.
11. Click the Generate button.
12. Scan the bar code with the RS5100.

Configure Task and VoiceConsole

1. Set the following advanced parameter in Task config
barcodeport = bt_scan
2. Turn on Bluetooth on the device.
3. View the properties of the device and ensure Bluetooth is enabled. If it is not enabled, click
Edit this device and set Bluetooth Enabled to "enabled".
4. Select Pair this device with a peripheral.
5. For Pairing type select "Bluetooth Scanner".
6. For Connection Mode select "Device listens for peripheral connection".
7. Set Security to "Enabled" or "Disabled" as desired.
8. If security is enabled, enter the security key as "12345" or a custom PIN if set.
9. Click Pair with peripheral to initiate pairing.
Voice Device and Headset Hardware Reference Guide 184