Table of Contents
Advertisement
SRX2 Pairing Modes
The SRX2 headset must be in high power pairing mode to pair with a handheld device. To place
the SRX2 headset in high power pairing mode, momentarily press the Plus (+) and Minus (-).
For pairing with third-party devices: By setting the SrxHighPowerPairingDelaySeconds
configuration parameter, you can configure how long an operator must hold the Plus and Minus
buttons before entering high-power pairing mode or set the parameter to have the headset go
directly into high-power pairing mode. After an SRX3 headset enters high power pairing mode, it
is available to accept a pairing initiated by a Bluetooth-enabled handheld device.
Pairing Methods
TouchConnect
An SRX2/SRX3 headset and an A700/A700x device can be paired by turning on the device and
headset and touching them together. No button presses are required.
NOTE
See "Pairing with A700/A700x Using TouchConnect™" for a full list of preconditions for using
this method.
Recommended for:
VoiceCatalyst users on A700/A700x devices and SRX2/SRX3 headsets
Why?
This method insures that the SRX2/SRX3 headset is only paired with the device it is touching.
There are no additional buttons to press.
Auto pairing
On startup or on removal from a charger, the device immediately searches for wireless headsets
and initiates a pairing. It eliminates the need to clear pairings manually as it will, by default, clear
a pairing when powered off or when placed into the charger.
NOTE
The SRX2 and SRX3 headset always power up in pairing mode.
Recommended for:
VoiceClient users sharing headsets
l
Anyone using SRX2/SRX3 headsets
l
Why?
When sharing headsets, autopairing makes it easy to locate any device and headset, power the
two on in close proximity to one another (less than 3 feet), and have the two pair automatically. It
eliminates the need to clear pairings manually or through VoiceConsole as it will clear a pairing
125
Voice Device and Headset Hardware Reference Guide
Advertisement
Table of Contents
Troubleshooting
