Spoken Error Messages - Honeywell A700 Hardware Reference Manual

Number Text
Flash failed to open the specified file in
0x210c
RAM.
Flash failed to read the specified file
0x210d
from RAM.
Flash failed to write the specified file to
0x210e
RAM.
0x210f Flash library failed while opening a file.
0x2110 Flash library failed while closing a file.
Flash had invalid flash file image
0x2111
generator linked list.
Flash is full. Please wait while Talkman
0x2112
turns off.
0x2115 Flash library failed. Out of space.
0x2116 Flash library failed during reclaim.

Spoken Error Messages

Error Message
"Battery is very low. Powering off. Must replace battery after
power off complete."
"Battery is getting low."
"Battery is getting low. Change battery now."
"Cannot load operator while sending templates."
"Cannot load task. Processing data."
"Corrupt task file. Task load failed."
"Corrupt device emulation config file. Task load failed."
"Corrupted operator data."
"Failed to load lookup table. Task load failed."
Voice Device and Headset Hardware Reference Guide
Solution
—
—
—
—
—
—
—
—
—
Solution
Change the battery.
Change the battery.
Change the battery.
Wait until all templates are loaded, then load the operator.
1. Turn the device off and then turn it back on again.
2. Reload the task.
3. Reboot the device.
4. Reload VoiceClient.
1. Turn the device off and then turn it back on again.
2. Reload the task.
3. Reboot the device.
4. Reload VoiceClient.
Reload the operator.
1. Go to an area of known good coverage.
2. Turn the device off and then turn it back on again.
3. Reload the task.
4. Reboot the device.
5. Reload VoiceClient.
266