Configure Task And Voiceconsole; Serial Peripherals; Serial Scanners; Serial Printers - Honeywell A700 Hardware Reference Manual

Configure task and VoiceConsole

1. Set the following advanced parameter in Task config
printerport = bt_print
2. Turn on Bluetooth on the A700x.
3. View the properties of the A700x and ensure Bluetooth is enabled. If it is not enabled, click
Edit this device and set Bluetooth Enabled to "enabled".
4. Select Pair this device with a peripheral.
5. For Pairing type select "Bluetooth Printer".
6. For Connection Mode select "Device initiates connection with peripheral".
7. In the Bluetooth Address field enter the Bluetooth MAC address of the scanner. This 12-
character ID is found
From the QL320 display under Bluetooth settings
l
8. If using security:
a. For Security select "Enabled."
b. For Security Key enter the key entered when enabling authentication for the PB22 or
PB50 in PrintSet 4.
9. Click Pair with peripheral to initiate pairing.

Serial Peripherals

Serial Scanners

To use a serial scanner with the A720/A720x::
1. Set the following advanced parameter in Task config
barcodeport = blue
2. Connect the serial scanner.

Serial Printers

To use a serial printer with the A720/A720x:
1. Set the following advanced parameters in Task config
barcodebaud = 9600
Printerport = red
2. Connect the serial printer.

Training Devices

QTERM-G55

The QTERM-G55 training device can be used with the A720/A720x. Configuration is the same as
with the A720. Refer to the
195
online instructions for using the QTERM-G55.
Voice Device and Headset Hardware Reference Guide