Charger Port Indicators; Battery Port Indicators - Honeywell A700 Hardware Reference Manual

Solid green LED: Charger power is on
l
No light: Charger power is off
l
Solid red LED: Charger is experiencing a power fault
l
NOTE
If the charger LED indicator is red, unplug the charger power supply from the power
source, and remove all batteries. Plug the power supply into the power source again. If
the LED remains red, the charger may require repair or replacement.
If the LEDs indicate that there is a problem, refer to information on troubleshooting to solve the
problem. See Troubleshooting Problems Indicated by

Charger Port Indicators

Additionally, each battery port has two LED indicator lights that apply to the status of the resident
battery.
The ring LED is a circular light that indicates the battery's charge status.
l
The alert LED, in the shape of an exclamation point (!), indicates that there is a battery
l
condition requiring attention. When this indicator is on, the battery on that charger port
may not last a full shift. Check VoiceConsole for a specific alert message.

Battery Port Indicators

The following chart describes the patterns for the battery port LED indicator lights.
Ring LED (Charge Status)
Solid Green
Solid Yellow
Blinking Red
Solid Green
Voice Device and Headset Hardware Reference Guide
LED.
Alert LED (Battery Health)
Off
Off
Off
Solid Red
Battery Status
Battery is fully charged
Battery is charging
Charging fault detected
Battery alert condition; fully charged
166