Replacing An Earpad On The Srx2/Srx3 Headset - Honeywell A700 Hardware Reference Manual

7. Slide the knob into the slot until it snaps into place.
8. Position the strap to go around the back of your head. The strap swivels freely on the two
knobs so that it can be positioned at the back of the head for either right-ear or left-ear
wearing of the headset.

Replacing an Earpad on the SRX2/SRX3 Headset

1. Hold the headset so that the earpad faces you and the electronic module faces away.
2. Grasp the earpad and earpad plate assembly and rotate them to the left to unlock the plate
from the headband.
3. Lift the pad and plate assembly off of the headband.
4. Install the replacement pad.
a. Remove the ear pad by pulling it away from the ear pad plate.
b. Slide one side of the new pad over the edge of the ear pad plate and gently stretch the
pad until it covers the plate.
c. Ensure that the lip of the new pad completely covers the ear pad plate all the way
around.
137 Voice Device and Headset Hardware Reference Guide