Storing The Srx2/Srx3 Hard-Hat Headset - Honeywell A700 Hardware Reference Manual

3. Slide the hard hat onto your head, pulling the earcup out as needed, then position the hat
so the earpad is snug against your ear.
4. If the earpad sits too low or high on your ear, take off the hard hat and adjust the earcup by
pulling or pushing the arms of the fork out of or into the fork sleeves.
5. Insert the SRX2/SRX3 electronic module into the pocket on the earcup by aligning the
notches on the speaker and earcup pocket.
6. Push the electronic module into the earcup pocket until it is firmly seated.

Storing the SRX2/SRX3 Hard-Hat Headset

Honeywell recommends storing the hard hat with the headset earcup moved up on the side of
the hat (see figure below) to reduce the risk of damage.
1. Remove the electronic module from the headset. The electronic module can be used by
another worker or stored separately.
2. Detach the microphone cap from the electronic module, and dock it in the mic cap pocket
located above the headset earcup.
3. Pull the earcup and fork assembly out away from the hard hat until the fork snaps into the
outer lock position.
4. Rotate the headset n the hard-hat clip until the earcup rests against the side of the hat.
Voice Device and Headset Hardware Reference Guide 116