Replacing The Ear Pad On The Sr-30, Sr-35 And The Sr-40 Headsets; Sr-35 Vocollect Hard-Hat Headset; Installing The Sr-35 Headset To A Hard Hat - Honeywell A700 Hardware Reference Manual

Replacing the Ear Pad on the SR-30, SR-35 and the SR-40
Headsets
1. With headset removed and disconnected, hold the headset in one hand.
2. At the seam on the bottom of the ear cup housing where the ear pad connects to the plastic
ear cup, pull the ear pad and plastic mounting plate outward until it disconnects.
3. Remove the worn ear pad from the plastic mounting plate and place the new ear pad over
the plastic mounting plate. Do not cover the three posts.
4. Line up the posts on the plastic mounting plate with the ear cup housing and snap into
place.

SR-35 Vocollect Hard-Hat Headset

The SR-35 Vocollect hard-hat headset has a built-in clip that fits most industrial hard hats. The
SR-35 headset can only be used with a hard hat that has a slot on the side that accepts a Peltor
clip. This clip is sold separately.

Installing the SR-35 Headset to a Hard Hat

1. Position the fork assembly so that the hard-hat clip is at the top end of the earcup, opposite
the cord end.
2. Push the clips on the two fork ends onto the pegs on either side of the earcup. Some force
is required.
3. Position the hard-hat clip with the tab pointing into the slot on the side of the hard hat. The
front of the clip with the screw should face away from the hard hat.
4. Slide the clip into the slot until it is firmly seated.
151 Voice Device and Headset Hardware Reference Guide