Data Manipulation; Multicode - Honeywell A700 Hardware Reference Manual

Registry Key
Initial1DSearchArea
DPMMode
Damaged1DCodes
ExtensiveBarcodeSearch

Data Manipulation

Data manipulation parameters provide for the manipulation of data after the bar code is scanned.
Parameter support is identified as follows:
X = Parameter is supported and available via Device Profile settings.
N/A = Parameter is not supported on this device.
NYI = Not Yet Implemented. These parameters should be considered unsupported, though they
can (with knowledge) be set via the CCI or advanced settings.

Multicode

Multiple Symbol Concatenation Support
Support for the parameters in the table is labeled as follows:
ü = Parameter is supported and available via the Scanner Options tab in the device profile.
X = Parameter is not supported on this device.
NYI = Not Yet Implemented. These parameters should be considered unsupported, though
they can (with knowledge) be set via the CCI or advanced settings.
IMPORTANT
A730 and A730x support for symbologies and parameters may differ. Refer to the table
below for details.
The registry keys in the table below are located under:
Voice Device and Headset Hardware Reference Guide
Default
A730
Value
0x0
ü
0x0 NYI
0x0
ü
0x0
ü
A730x Description
For 1D bar codes, sets the initial
search area.
0 = center,
1 = upper half,
ü
2 = lower half,
3 = full,
4 = "smart raster" (better for non-
horizontal).
Enhances the ability to read a DPM
(Direct Product Marking) bar code
NYI
where the bar code is marked directly
on the product.
Enhances the ability to read damaged
ü
or badly printed 1D bar codes.
The decoding algorithms spend more
ü
time trying to find a bar code.
70