Imager - Honeywell A700 Hardware Reference Manual

[HKEY_LOCAL_MACHINE\Software\Vocollect\Imager\Decoding Security]
Registry Key
CenterDecoding
CenterDecodingTolerance

Imager

Imager configuration
Support for the parameters in the table is labeled as follows:
ü = Parameter is supported and available via the Scanner Options tab in the device profile.
X = Parameter is not supported on this device.
NYI = Not Yet Implemented. These parameters should be considered unsupported, though
they can (with knowledge) be set via the CCI or advanced settings.
IMPORTANT
A730 and A730x support for symbologies and parameters may differ. Refer to the table
below for details.
The registry keys in the table below are located under:
[HKEY_LOCAL_MACHINE\Software\Vocollect\Imager\Imager]
Registry Key
DecodeMode
AimerFlashing
69
Default
A730
Value
0x0
ü
0x0
ü
Default
A730
Value
0x1
ü
0x1
ü
Voice Device and Headset Hardware Reference Guide
A730x Description
Only decodes a bar code if it is in the
ü
center of the frame.
Amount of tolerance for what is
considered the "center". Range is 0x0 -
ü
0x64 (0 to 100), where "0x0" is the
least tolerant (must be aimed exactly).
A730x Description
Decoding mode, where
0 = linear imager emulation, and
ü
1 = 2D imager.
Aimer mode, where
0 = on,
1 = decode optimized (flashing at
ü
frame rate), and
2 = off.