Zebra Rs6000 Scanner; Scanner As Initiator; Configure Rs6000 Scanner - Honeywell A700 Hardware Reference Manual

Zebra RS6000 Scanner

NOTE
The process below connects the peripheral using the Default profile. To use the Master
profile, set the following:
[HKEY_LOCAL_MACHINE\Software\Vocollect\NetworkD\RadioSettings]
TerminalRoleSRX=master
TerminalRoleOther=master

Scanner as Initiator

Configure RS6000 Scanner

1. Download and install the following on your PC from the Zebra website:
Zebra 123Scan:
l
https://www.zebra.com/us/en/products/software/scanning-systems/123scan.html
Zebra PC Tool:
l
https://www.zebra.com/us/en/support-downloads/software/utilities/pc-tool.html
2. Perform a clean boot for the scanner:
a. Remove the battery.
b. Press and hold the Restore key.
c. Insert the battery into the scanner while continuing to hold the Restore key.
d. After approximately 5 seconds a chirp is heard and the scan LEDs flash green. This
signals the RS6000 is set to the default factory configuration.
3. Connect the RS6000 scanner to the PC with 123Scan installed using the USB cable.
4. Start the 123Scan utility.
a. Select Create new configuration file.
b. Select My scanner is connected via USB cable.
c. Select your scanner from the list.
d. Provide a name for the configuration file.
e. Click on Modify Data.
f. Select Append an enter key.
g. Click Done and Load to scanner.
5. Scan the SSP Bluetooth Classic Bar Code.
6. Remove and reinstall the RS6000 battery.
7. The scanner reboots and is discoverable as a Bluetooth device.
8. Open the PC Tool application.
9. Click the Show Bluetooth Address barcode button.
10. Enter the Bluetooth address of the RS6000 scanner.
11. Click the Generate button.
12. Scan the bar code with the RS6000.
185 Voice Device and Headset Hardware Reference Guide