Matrix 2 Of 5 - Honeywell A700 Hardware Reference Manual

Registry Key
Interleaved2of5ReadingTolerance
Interleaved2of5BarCodeLengthL1
Interleaved2of5BarCodeLengthL2
Interleaved2of5BarCodeLengthL3
Interleaved2of5BarCodeLengthMode
Interleaved
2of5CheckDigitTransmission
Interleaved2of5UDSI

Matrix 2 of 5

Support for the parameters in the table is labeled as follows:
ü = Parameter is supported and available via the Scanner Options tab in the device profile.
X = Parameter is not supported on this device.
NYI = Not Yet Implemented. These parameters should be considered unsupported, though
they can (with knowledge) be set via the CCI or advanced settings.
IMPORTANT
A730 and A730x support for symbologies and parameters may differ. Refer to the table
below for details.
The registry keys in the table below are located under:
[HKEY_LOCAL_MACHINE\Software\Vocollect\Imager\Matrix 2 of 5]
Registry Key
Matrix2of5Activation
Voice Device and Headset Hardware Reference Guide
Default
A730
Value
0x0
ü
0x6
ü
0x0
ü
0x0
ü
0x0
ü
0x0
ü
B2
ü
Default
A730
Value
0x0
ü
A730x Description
Tolerance for reading "hard to read"
bar codes, where
X 0 = high,
1 = medium, and
2 = low.
Length value L1. Range is 0x0 to 0xFF
ü
(0 to 255).
Length value L2. Range is 0x0 to 0xFF
ü
(0 to 255).
Length value L3. Range is 0x0 to 0xFF
ü
(0 to 255).
Length verification mode, where
0 = "L1 is min length",
1 = "L1, L2, L3 are fixed lengths" – Not
ü
supported on A730x,
2 = "L1 is min, L2 is max length".
Enable transmission of the check digit.
ü
User-defined symbology identifier.
ü
Range is 0-4 characters.
A730x Description
Enables the MSI Code symbology.
ü
46