Commissioning; Installation; Important Information For Installation/Commissioning - B&R Automation PC 3100 User Manual

3 Commissioning

3.1 Installation

Danger!
• The entire power supply must be disconnected before removing any covers or components
from the device and installing or removing any accessories, hardware or cables.
• Remove the power cable from the device and from the power supply.
• All covers and components, accessories, hardware and cables must be installed or secured
before the device is connected to the power supply and switched on.

3.1.1 Important information for installation/commissioning

• Check the delivery.
° When accepting the delivery, check the packaging for visible transport damage.
° If transport damage has occurred, this must be documented immediately and a complaint lodged
or confirmed by the shipping/delivery service.
° Keep the original packaging for further transport.
Information:
If a device is transported or stored without packaging, all environmental influences such
as shocks, vibrations, pressure and moisture have an unprotected effect on the device.
Damaged packaging indicates that the device has been severely affected by environ-
mental influences and may have been damaged.
This can result in malfunctions of the device, machine or system.
° Check the contents of the packaging and the optionally ordered accessories for completeness and
damage.
° If the contents of the packaging are incomplete, damaged or do not correspond to your order, you
must immediately inform your responsible sales office or B&R Headquarters.
Danger!
A damaged device has unpredictable properties and states. The unintentional installa-
tion or startup of a damaged device must be prevented. The damaged device must be
marked as such and made inaccessible, or it must be returned for repairs immediately.
• The ambient conditions must be observed –
Caution!
Before the device is started up, it must be gradually adapted to room temperature! Exposure to
direct heat radiation is not permitted. During transport at low temperatures or large temperature
fluctuations, the collection of moisture in or on the device is not permitted. Moisture can cause
short circuits in electrical circuits and damage the device.
• When installing the device, the permissible mounting orientations must be observed -
entations".
Caution!
Inclined installation reduces the air convection through the device and thus the maximum per-
missible ambient temperature for operation. If there is sufficient external ventilation in an in-
clined mounting orientation, the maximum permissible ambient temperature must be checked
in each individual case. Failure to do so may result in damage to the equipment and void the
certifications and warranty for the device.
Automation PC 3100 User's manual V 1.00 Translation of the original documentation
see "Environmental properties".
Commissioning
see "Mounting ori-
121