B&R Automation PC 3100 User Manual page 68

Technical data
The following shows an overview of the video signals possible on the SDL4 output.
Graphics option
5ACCLI02.SD40-000
Information:
Hot plugging display devices on the SDL4 interface for service purposes is supported by the hardware
and graphic drivers of approved operating systems. The female RJ45 connector is specified for 500
mating cycles.
Information:
If a display device with touch screen is disconnected from and reconnected to the SDL4 interface
during operation (hot plugging), it may be necessary to recalibrate the touch screen.
2.3.4.3.3.2 Cable lengths and resolutions for SDL4 transfer
The maximum cable length for SDL4 transfers is 100 m with a B&R
resolution).
2.3.4.3.3.3 SDL4 LEDs
The LEDs are located under the SDL4 interface.
LED Color Status
Link Yellow On
Off
Status Yellow On
Blinking
68
SDL4 interface
Video signals
SDL4
Table 61: SDL4 interface
SDL4 LEDs
Explanation
Indicates an active SDL4 connection.
No active SDL4 connection.
The SDL4 connection is established and OK.
No active SDL4 connection.
Table 62: SDL4 LEDs
Automation PC 3100 User's manual V 1.00 Translation of the original documentation
RJ45 connector, female
"SDL3/SDL4 cables" (regardless of the panel
LED "Link" LED "Status"