Interface Options; 5Ac901.I232-00 - B&R Automation PC 3100 User Manual

2.3.5 Interface options

Information:
It is important to note that not every interface option can be connected in interface slots 1 and 2. For
more information, see sections
Information:
For information about replacing or installing an interface option, see section
option and DDR4 SDRAM" on page
Depending on the IF option used, it may be necessary to load the default settings in BIOS after replace-
ment or installation

2.3.5.1 5AC901.I232-00

2.3.5.1.1 General information
Interface option 5AC901.I232-00 is equipped with an RS232 interface.
• 1x RS232 interface
• Compatible with APC910/PPC900 and APC3100/PPC3100
2.3.5.1.2 Order data
Model number Short description
Interface options
5AC901.I232-00 Interface card - 1x RS232 interface - For APC910/PPC900/
APC3100/PPC3100
2.3.5.1.3 Technical data
Information:
The following specified characteristic data, features and limit values are only valid for this accessory
and may differ from those of the complete system. The data specified for the complete system applies
to the complete system in which this accessory is installed, for example.
Model number
General information
B&R ID code
Interfaces
COM
Type
Design
UART
Max. baud rate
Electrical characteristics
Power consumption
Operating conditions
Pollution degree per EN 61131-2
Environmental conditions
Temperature
Operation
Storage
Transport
Automation PC 3100 User's manual V 1.00 Translation of the original documentation
"IF option 1 slot" on page 46
254.
(see "Exit" on page 175).
Table 63: 5AC901.I232-00 - Order data
Table 64: 5AC901.I232-00 - Technical data
and "IF option 2 slot" on page
5AC901.I232-00
0xF400
RS232, modem supported, not galvanically isolated
DSUB, 9-pin, male
16550-compatible, 16 byte FIFO
115 kbit/s
1 W
Pollution degree 2
0 to 60°C
1)
-20 to 60°C
-20 to 60°C
Technical data
47.
"Installing the interface
Figure
69