Command 0X58 - Request Device Certificate - Magtek DynaPro Go Programmer's Manual

4 - Command Set

4.3.29 Command 0x58 - Request Device Certificate

The host uses this command to request a certificate stored on the device.
If an error occurs, the device terminates the command and reports the error in ACKSTS of Command
0x01 - Response ACK. For a full list of error codes, see Command 0x01 - Response ACK.
If no error occurs, the device sends the Device Certificate to the host in DER encoded X.509 format using
Report 0x29 - Send Big Block Data to Host.
Table 4-48 - Usage Table for Command 0x58 (Request Device Certificate)
Bit 7
Byte 0 0x58
Byte 1 0x02 = Read
Byte 2 Reserved
DynaPro Go| Handheld PIN Pad Device with MSR/Contact/Contactless | Programmer's Manual (COMMANDS)
6 5
Reserved Reserved Reserved Reserved
Page 87 of 247 (D998200136-31)
4 3 2
Reserved Reserved
1 0
Device
Certificate