Command 0X08 - Request Device Status - Magtek DynaPro Go Programmer's Manual

Handheld pin pad device with msr/contact/contactless
Table of Contents

Advertisement

4 - Command Set

4.3.8 Command 0x08 - Request Device Status

This command directs the device to send current information (Session State, Device State and Status, etc.)
to the host. Following this command, the device sends the host Report 0x20 - Device State Report.
Table 4-9 - Usage Table for Command 0x08
Bit
7
Byte 0
0x08
Byte 1
0x00
DynaPro Go| Handheld PIN Pad Device with MSR/Contact/Contactless | Programmer's Manual (COMMANDS)
6
5
4
Page 52 of 247 (D998200136-31)
3
2
1
0

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the DynaPro Go and is the answer not in the manual?

Table of Contents