Command 0X03 - Request Swipe Card - Magtek DynaPro Go Programmer's Manual

4 - Command Set

4.3.3 Command 0x03 - Request Swipe Card

This command directs the device to prompt the cardholder to swipe a card by displaying one of four
predetermined messages (see Card Message ID in Table 4-4). Example request screens look like this:
If an error occurs, the device terminates the command and reports the error in ACKSTS of Command
0x01 - Response ACK. For a full list of error codes, see Command 0x01 - Response ACK.
When this command completes (card swiped OK, cardholder or operator cancelled, or timeout), the
device sends Report 0x22 - Card Status Report to the host. If the Card and Operation Status are both
OK, the host should then send Command 0x0A - Request MSR Data to get the card data.
For an example of using this command, see Appendix A.1 How to Get MSR/PIN Data from the Device
for a Bank Simulation.
Table 4-4 - Usage Table for Command 0x03
Bit 7
Byte 0 0x03
Byte 1 Wait time in seconds, (0x01..0xFF; 0x00 = Infinite wait time)
DynaPro Go| Handheld PIN Pad Device with MSR/Contact/Contactless | Programmer's Manual (COMMANDS)
Figure 4-2 - DynaPro Go Swipe Prompts
6 5 4
Page 42 of 247 (D998200136-31)
3 2 1 0