4 - Command Set
4.3.24 Command 0x1D - Set Bluetooth LE Module Control Data (Bluetooth LE Only | PCI
Bluetooth LE Only)
This command sends control data to the Bluetooth LE module, which controls Bluetooth LE
communications. The device first responds to the host's followup Command 0x01 - Response ACK.
After the device processes the Bluetooth LE module control data, it responds with Report 0x2D -
Bluetooth LE Module Control Data (Bluetooth LE Only | PCI Bluetooth LE Only). It is important to
understand that even though this is implemented as a feature report to be used in Set mode, it can be used
to send requests to discover the current property settings in the Bluetooth LE module. The full set of
Bluetooth LE module controls can be found in Appendix J Bluetooth LE Module Control Messages
(Bluetooth LE Only | PCI Bluetooth LE Only).
Table 4-43 - Usage Table for Command 0x1D
Bit
7
Byte 0
0x1D (command identifier)
Byte 1
Control data length (defined in Appendix J)
Bytes 2 to
(2+control
Control data (defined in Appendix J)
data length-1)
Bytes (2 +
control data
Padding. Set all bytes to zero.
length) to 63
DynaPro Go| Handheld PIN Pad Device with MSR/Contact/Contactless | Programmer's Manual (COMMANDS)
6
5
4
Page 79 of 247 (D998200136-31)
3
2
1
0
Need help?
Do you have a question about the DynaPro Go and is the answer not in the manual?