Bluetooth Le Module Commands; About Bluetooth Le Module Commands - Magtek DynaPro Go Programmer's Manual

Appendix J - Bluetooth LE Module Control Messages (Bluetooth LE Only | PCI Bluetooth LE Only)
J.1

Bluetooth LE Module Commands

J.1.1 About Bluetooth LE Module Commands
For details about how to send these messages to the Bluetooth LE module, see Command 0x1D - Set
Bluetooth LE Module Control Data (Bluetooth LE Only | PCI Bluetooth LE Only).
The general formats for control messages in this section are as follows, and the specific commands can be
found in subsequent sections:
Byte 0 Message type
0x00 = Request
0x01 = Response
0x02 = Notification
Command request message format
Byte 1 Command identifier
Byte 2..n Command request data
Command response message format
Byte 1 Response Code
0x00 (success)
0x01 (failure)
0x02 (bad parameters)
Bytes 2..n Command response data
Notification message format
Byte 1 Notification identifier
Byte 2..n Notification data
DynaPro Go| Handheld PIN Pad Device with MSR/Contact/Contactless | Programmer's Manual (COMMANDS)
Page 231 of 247 (D998200136-31)