Command 0Xe5 - Get 802.11 Wireless Network Info (802.11 Wireless Only) - Magtek DynaPro Go Programmer's Manual

4 - Command Set

4.6.5 Command 0xE5 - Get 802.11 Wireless Network Info (802.11 Wireless Only)

The host uses this command to retrieve wireless connection information from the device. The host must
use the USB connection to call this command, and must first successfully unlock the device's 802.11
wireless settings by calling Command 0xE1 - Unlock Wireless Network Configuration (802.11
Wireless Only).
The host should first call the command in Set mode to specify what wireless connection information it
wants to retrieve, then receive the standard ACKSTS response, then call the same command in Get mode
to retrieve the requested information. The device's response to the Get call is formatted as defined in
Command 0xE4 - Set 802.11 Wireless Network Configuration (802.11 Wireless Only). If valid
information is not available, the data block will be all zeroes.
If an error occurs, the device terminates the command and reports the error in ACKSTS of Command
0x01 - Response ACK. For a full list of error codes, see Command 0x01 - Response ACK.
Table 4-97 - Usage Table for Command 0xE5 - Get 802.11 Wireless Network Info (Set mode / Get mode)
Bit 7
Byte 0 0xE5
Network Information ID:
0x00 = Access Point Connection
0x01 = Reserved
Byte 1
0x02 = Reserved
0x03 = Device 802.11 Wireless TCP/IP Settings
0x04 = Host ID Configuration
DynaPro Go| Handheld PIN Pad Device with MSR/Contact/Contactless | Programmer's Manual (COMMANDS)
6 5 4
Page 150 of 247 (D998200136-31)
3 2 1 0