Command 0X06 - Request Cardholder Selection - Magtek DynaPro Go Programmer's Manual

4 - Command Set

4.3.6 Command 0x06 - Request Cardholder Selection

This command directs the device to prompt the cardholder to select the transaction type (debit, credit,
etc.) or to verify the transaction amount, as shown below. For information about setting custom status
messages, see Appendix G Custom Messages.
Figure 4-4 - DynaPro Go Cardholder Selection Screens
If an error occurs, the device terminates the command and reports the error in ACKSTS of Command
0x01 - Response ACK. For a full list of error codes, see Command 0x01 - Response ACK.
After the cardholder makes a selection or cancels, or if a timeout occurs based on Wait Time, the device
does the following:
1) Clear the display
2) Return to the idle state
3) Send Report 0x25 - Cardholder Selection Response Report to the host
DynaPro Go| Handheld PIN Pad Device with MSR/Contact/Contactless | Programmer's Manual (COMMANDS)
Page 48 of 247 (D998200136-31)