Command 0X07 - Display Message - Magtek DynaPro Go Programmer's Manual
Handheld pin pad device with msr/contact/contactless
Hide thumbs
Also See for DynaPro Go:
- Installation and operation manual (77 pages) ,
- Quick installation manual (4 pages) ,
- Programmer's reference manual (75 pages)
Table of Contents
Advertisement
4 - Command Set
4.3.7 Command 0x07 - Display Message
This command directs the device to display a predefined message for a specified time. Examples are
shown below. For information about setting custom status messages, see Appendix G Custom
Messages.
DynaPro Go| Handheld PIN Pad Device with MSR/Contact/Contactless | Programmer's Manual (COMMANDS)
Figure 4-5 - DynaPro Go Messages
Page 50 of 247 (D998200136-31)
Advertisement
Table of Contents
Need help?
Do you have a question about the DynaPro Go and is the answer not in the manual?