Report 0X27 - Display Message Done Report - Magtek DynaPro Go Programmer's Manual
Handheld pin pad device with msr/contact/contactless
Hide thumbs
Also See for DynaPro Go:
- Installation and operation manual (77 pages) ,
- Quick installation manual (4 pages) ,
- Programmer's reference manual (75 pages)
Table of Contents
Advertisement
4 - Command Set
4.4.8 Report 0x27 - Display Message Done Report
The device sends this report to the host to indicate a pending Command 0x07 - Display Message has
completed.
Table 4-64 - Usage Table for Report 0x27
Bit
7
Byte 0
0x27
Byte 1
Operation Status (see Table 4-99 - Operation Status Codes on page 163)
DynaPro Go| Handheld PIN Pad Device with MSR/Contact/Contactless | Programmer's Manual (COMMANDS)
6
5
4
Page 101 of 247 (D998200136-31)
3
2
1
0
Advertisement
Table of Contents
Need help?
Do you have a question about the DynaPro Go and is the answer not in the manual?