Command 0X33 - Get Bin Whitelist Table - Financial Format; Whitelist Only) - Magtek DynaPro Go Programmer's Manual

4 - Command Set
4.3.27 Command 0x33 - Get BIN Whitelist Table - Financial Format (Financial Format

Whitelist Only)

The device supports a BIN whitelist for financial cards that holds up to six six-digit Bank Identification
Numbers (BINs). After a cardholder swipes a financial card, the device looks up the card's BIN in this
whitelist. If it finds the card's BIN and if the card's PAN is longer than the Max Financial PAN Length
in section 2.4 About Device Features, the device will not encrypt data ID 4, 5 or 6 in the Report 0x23 -
Card Data Report it sends to the host.
The host uses this command to request the device send the current contents of the financial format
whitelist BIN table to the host. The device responds in the following format:
Table 4-46 - Usage Table for Command 0x33 (Get mode)
Bit 7
Byte 0 0x33
Byte 1 Number of bytes to follow (36 = 0x24 for the 6 slots at 6 bytes each)
Bytes 2..7 Raw BIN stored in whitelist slot 1
Bytes 8..13 Raw BIN stored in whitelist slot 2
Bytes 14..19 Raw BIN stored in whitelist slot 3
Bytes 20..25 Raw BIN stored in whitelist slot 4
Byte 26..31 Raw BIN stored in whitelist slot 5
Byte 32..37 Raw BIN stored in whitelist slot 6
If an error occurs, the device terminates the command and reports the error in ACKSTS of Command
0x01 - Response ACK. For a full list of error codes, see Command 0x01 - Response ACK.
DynaPro Go| Handheld PIN Pad Device with MSR/Contact/Contactless | Programmer's Manual (COMMANDS)
6 5
Page 84 of 247 (D998200136-31)
4 3 2 1 0