How To Use Network Connections (Ethernet Only | 802.11 Wireless Only) - Magtek DynaPro Go Programmer's Manual

3 - Connection Types
3.3 How to Use Network Connections (Ethernet Only | 802.11 Wireless
Only)
When the device is connected to the host via a 10/100 Ethernet port or 802.11 wireless, on power-up the
device attempts to contact a DHCP server to acquire a dynamic IP address. If the device is configured to
use a static IP address, it uses its preconfigured IP address instead.
The default port for the host to communicate with the device is TCP/IP port 26.
On some devices, network functionality and the following network-related keypad commands are only
enabled when the device's USB cable is not connected.
To show the MAC address of the device, press keypad buttons
function key .
To show the current IP address of the device, press keypad buttons
.
function key
DynaPro Go| Handheld PIN Pad Device with MSR/Contact/Contactless | Programmer's Manual (COMMANDS)
Page 32 of 247 (D998200136-31)
Left function key 6 2 2 Right
,
Left function key 4 7 2 Right