Magtek DynaPro Go Quick Installation Manual

Handheld pin pad device with msr / contact / contactless

Hide thumbs Also See for DynaPro Go:

Table of Contents

Download this manual

DynaPro Go

Handheld PIN Pad Device with

MSR/Contact/Contactless

Quick Installation Guide

DynaPro Go

Installing DynaPro Go is straightforward: Configuration is done prior to deployment for the

certificate authority public keys and terminal and payment brand settings; end users need only set

up a host with appropriate software, configure the software, and connect the device to the host.

Compatible Operating Systems

iOS 7.1 and later

Android 4.4.2 and later

Windows 7, Windows 8.1, Windows 10

Table of Contents

Do you have a question about the DynaPro Go and is the answer not in the manual?

Page 1 Quick Installation Guide DynaPro Go Installing DynaPro Go is straightforward: Configuration is done prior to deployment for the certificate authority public keys and terminal and payment brand settings; end users need only set up a host with appropriate software, configure the software, and connect the device to the host.
Page 2 Contents/Pre-Installation Checklist The major components of DynaPro Go are shown in Figure 1. In addition to the components shown, the device has a tam- per trigger recessed in the bottom that is intended for manufacturer use only. DO NOT INSERT ANYTHING INTO THE TAMPER TRIGGER HOLE! DOING SO WILL ERASE ALL INJECTED KEYS; THE DE- VICE WILL STOP FUNCTIONING, AND WILL HAVE TO BE RETURNED TO THE MANUFACTURER FOR RE-CONFIGURATION.
Page 3 Obtain a copy of IPADSim_9.0.2.58 or later from MagTek and run on the host. Make sure to only have one MagTek connected device at a time. Make sure the device is powered off and is not connected to a USB port. Install DynaPro Go to Public Root CA certificate for secure socket connections to the Host using method TLS1.2 with mutual authentication.
Page 4 When contacting the support team make sure the device is charged, and have the part number and serial number(s) available. MagTek ® Inc., 1710 Apollo Court, Seal Beach CA 90740 p 562-546-6400 | f 562-546-6301 | 800-788-6835 | www.magtek.com Registered to ISO 9001:2000 © Copyright 2017 MagTek, Inc. PN D998200135 rev 20 7/17...