Magtek DynaPro Go Programmer's Manual page 123

4 - Command Set
6) If the cardholder confirms the amount or makes a payment type selection, then depending on the card
type the host specified in the command, the device arms the MSR and/or ICC slot, turns on the LED
near the slot (if any), and displays either
button or the transaction times out, the device performs Command 0xA2 Completion.
Cancel
Figure 4-17 – DynaPro Go Request Start EMV Transaction Insert Card - Contact Only
Figure 4-18 – DynaPro Go Request Start EMV Transaction Insert Card - Contactless Only
Figure 4-19 – DynaPro Go Request Start EMV Transaction Insert Card - Contactless and MSR
DynaPro Go| Handheld PIN Pad Device with MSR/Contact/Contactless | Programmer's Manual (COMMANDS)
or
SWIPE INSERT CARD
Page 123 of 247 (D998200136-31)
. If the cardholder presses the