Command 0X12 - Request Cardholder Signature (Sc-S Only | Sc-F Only) - Magtek DynaPro Go Programmer's Manual

4 - Command Set

4.3.17 Command 0x12 - Request Cardholder Signature (SC-S Only | SC-F Only)

This command directs the device to request the cardholder's signature in the screen shown below:
If an error occurs, the device terminates the command and reports the error in ACKSTS of Command
0x01 - Response ACK. For a full list of error codes, see Command 0x01 - Response ACK.
If no error occurs, the device sends Report 0x28 - Signature Capture State Report to the host.
Table 4-22 - Usage Table for Command 0x12
Bit 7
Byte 0 0x12
Byte 1 Wait Time in seconds, (0x01..0xFF; 0x00 = 256 seconds)
Options:
Byte 2 0x00 = Timeout clears any signature data
0x01 = Timeout returns timeout status plus length collected. Sig Data can be requested.
Beeper Behavior (Optional. Only changes device behavior if Beeper Mode = Enabled in
Byte 3 Command 0x09 - Set / Get Device Configuration). See Table 4-101 - Beeper Behavior
Codes on page 163 for possible values.
DynaPro Go| Handheld PIN Pad Device with MSR/Contact/Contactless | Programmer's Manual (COMMANDS)
Figure 4-8 - DynaPro Go Signature Capture Screen
6 5
Page 68 of 247 (D998200136-31)
4 3 2 1 0