Command 0Xa8 - Get Kernel Info - Magtek DynaPro Go Programmer's Manual

4 - Command Set

4.5.7 Command 0xA8 - Get Kernel Info

This command directs the device to send the requested kernel information to the host.
Table 4-80 - Usage Table for Command 0xA8 Set Mode
Bit 7
Byte 0 0xA8
Byte 1 Kernel Info ID (see Table 4-82)
If an error occurs, the device terminates the command and reports the error in ACKSTS of Command
0x01 - Response ACK. For a full list of error codes, see Command 0x01 - Response ACK.
If no error occurs, the host should call Command 0x08 - Request Device Status in Get mode to retrieve
a response in the following format:
Table 4-81 - Usage Table for Command 0xA8 Get Mode
Bit 7
Byte 0 0xA8
Byte 1 Kernel Info ID (see Table 4-82)
Byte 2 Data length
Bytes 3..63 Block data
Table 4-82 - 0xA8 Kernel Info IDs
Info ID
0x00 Version - L1 Kernel
0x01 Version - L2 Kernel LIB
0x02 Version - CL1 Kernel (Chip Card Contactless Only, otherwise Reserved)
0x03 Version - L2 HAL
0x04 Version - S/W LIB
0x05 Version - CL2 HAL (Chip Card Contactless Only, otherwise Reserved)
0x06 Version - CL2 Entry Point (Chip Card Contactless Only, otherwise Reserved)
0x07 Version - CL2 PayPass/MCL Kernel (Chip Card Contactless Only, otherwise Reserved)
0x08 Version - CL2 payWave Kernel (Chip Card Contactless Only, otherwise Reserved)
0x09 Version - CL2 Expresspay Kernel (Chip Card Contactless Only, otherwise Reserved)
0x0A Version - CL2 D-PAS Kernel (Chip Card Contactless Only, otherwise Reserved)
0x10 Checksum/Signature - L1 Kernel
0x11 Checksum/Signature - L2 Kernel LIB
0x12 Checksum/Signature - L2 Kernel Configuration
0x13 Checksum/Signature - L2 HAL
DynaPro Go| Handheld PIN Pad Device with MSR/Contact/Contactless | Programmer's Manual (COMMANDS)
6 5 4
6 5 4
Description
Page 131 of 247 (D998200136-31)
3 2 1
3 2 1
0
0