Magtek DynaPro Go Programmer's Manual page 55

4 - Command Set
Bit 7
Device Control 2 (default value = 0x00)
Bit 0 Reserved
Bit 1 ARPC MAC Checking (EMV Only)
Configure MAC requirement on inbound online response for Command 0xA4 - Acquirer
Response ARPC (MAC-MSR):
0 = Enable (default)
1 = Disable
Byte 2
Bit 2 Financial + ICC Card Type Reporting:
Configure Financial+ICC Card type reporting
0 = Enable (default)
1 = Disable
Bit 3 ARQC and Batch Data Output Format (Protected):
0 = DynaPro Format (default)
1 = Reserved
Mask Configuration (default value = 0xC0, all enabled except Reserved bits)
ISO Mask
0 = Disable
Byte 3
1 = Enable
MSR Card Configuration (default value = 0xD5, all enabled)
AAMVA
Byte 4
Card
0 = Disable
1 = Enable
Mask Character (factory setting is 0x30 representing ASCII '0')
Byte 5
Leading length to leave unmasked. In SRED,
Byte 6
maximum length = 6.
EMV L2 ICS Configuration (Default = 0x01)
Byte 7
Note: This setting is ignored when EMV Mode is disabled.
DynaPro Go| Handheld PIN Pad Device with MSR/Contact/Contactless | Programmer's Manual (COMMANDS)
6 5
Check Digit
MS2.0 Enable
0 = Disable
00 = MS2.0 Disabled
1 = Enable
Track 3 Data
Non-finance 00 = Disabled
card option 01 = Enabled
11 = Required
Page 55 of 247 (D998200136-31)
4 3 2
Reserved
Track 2 Data
00 = Disabled
01 = Enabled
11 = Required
Trailing length to leave unmasked. In
SRED, maximum length = 4.
1 0
Reserved
Track 1 Data
00 = Disabled
01 = Enabled
11 = Required