Wireless Connection Commands And Reports (802.11 Wireless Only | Pci Bluetooth Le Only) - Magtek DynaPro Go Programmer's Manual
Handheld pin pad device with msr/contact/contactless
Hide thumbs
Also See for DynaPro Go:
- Installation and operation manual (77 pages) ,
- Quick installation manual (4 pages) ,
- Programmer's reference manual (75 pages)
Table of Contents
Advertisement
4 - Command Set
4.6
Wireless Connection Commands and Reports (802.11 Wireless Only |
PCI Bluetooth LE Only)
This section contains commands used to configure the device's wireless connection. These commands
can only be sent using the USB interface. (802.11 Wireless Only) Sending these commands requires the
host to first send Command 0xE1 - Unlock Wireless Network Configuration (802.11 Wireless Only).
The host can then configure the device's network settings by using the other commands in this section.
DynaPro Go| Handheld PIN Pad Device with MSR/Contact/Contactless | Programmer's Manual (COMMANDS)
Page 141 of 247 (D998200136-31)
Advertisement
Table of Contents
Need help?
Do you have a question about the DynaPro Go and is the answer not in the manual?