Command 0Xae - Mcl Send Det Command (Mcl 3.1 Support Only) - Magtek DynaPro Go Programmer's Manual

4 - Command Set

4.5.10 Command 0xAE - MCL Send DET Command (MCL 3.1 Support Only)

The host uses this command to send a Send DET command and DET strings to the MCL kernel.
The host should first send Command 0x10 - Send Big Block Data to Device to load the DET strings into
the device, then call this command to send them to the kernel. The host should send as many blocks as
necessary to send all DETs in the following format using the 60-byte Packet Data field:

The first byte should indicate DET Status (0x00 = OK there are DETs; 0x70 = No Matching DEK;
0x71 = DET Empty).

The next byte should indicate the total number of DETs the host is sending.

The subsequent bytes across as many blocks as needed should contain data for all DETs the host is
sending, in this format:
o DET Number (starting with 0x01)
o DET Data Length MSB
o DET Data Length LSB
o DET Data
o [Repeat for subsequent DETs]
Table 4-89 - Usage Table for Command 0xAE
Bit 7
Byte 0 0xAE
Byte 1 0
Byte 2 Reserved
Byte 3 Reserved
If an error occurs, the device terminates the command and reports the error in ACKSTS of Command
0x01 - Response ACK. For a full list of error codes, see Command 0x01 - Response ACK.
DynaPro Go| Handheld PIN Pad Device with MSR/Contact/Contactless | Programmer's Manual (COMMANDS)
6 5 4
Page 140 of 247 (D998200136-31)
3 2 1 0