Command 0X0A - Request Msr Data - Magtek DynaPro Go Programmer's Manual

4 - Command Set

4.3.10 Command 0x0A - Request MSR Data

This command directs the device to send MSR data to the host; it should be issued after a Command
0x03 - Request Swipe Card command has successfully completed.
If an error occurs, the device terminates the command and reports the error in ACKSTS of Command
0x01 - Response ACK. For a full list of error codes, see Command 0x01 - Response ACK.
If no error occurs, the device sends multiple instances of Report 0x23 - Card Data Report to the host. If
no MSR data is available, the device sends a single Report 0x23 - Card Data Report containing a Data
Length of 0.
Table 4-11 - Usage Table for Command 0x0A
Bit 7
Byte 0 0x0A
Byte 1 0x00
DynaPro Go| Handheld PIN Pad Device with MSR/Contact/Contactless | Programmer's Manual (COMMANDS)
6 5 4
Page 57 of 247 (D998200136-31)
3 2 1 0