Basic Line Editing Commands - Cabletron Systems SmartSwitch 6000 Installation & User Manual

The command prompt will show the name of the 6SSRM-02 in front of the mode
Note:
character(s). The default name is "ssr". The procedure in
Information" on page 3-4
When you are in Configure or Enable mode, use the exit command or press Ctrl+Z to exit to the
previous access mode.
Note: When you exit Configure mode, the CLI will ask you whether you want to activate the
configuration commands you have issued. If you enter yes or y, the configuration
commands you issued are placed into effect and the 6SSRM-02's configuration is
changed accordingly. However, the changes are not written to the Startup configuration file
in the 6SSRM-02's boot flash and therefore are not reinstated after a reboot. See
"Activating Configuration Changes and Saving the Configuration File" on page 3-17
information about saving configuration changes.

Basic Line Editing Commands

The CLI supports EMACs-like line editing commands. The following table lists some commonly
used commands. For a complete set of commands, see the SmartSwitch Router User Reference
Manual.
Key sequence
Ctrl+A
Ctrl+B
Ctrl+D
Ctrl+E
Ctrl+F
Ctrl+N
Ctrl+P
Ctrl+U
Ctrl+X
Ctrl+Z
describes how to change the system name.
Table 3-1 Some commonly used CLI commands
Move cursor to beginning of line
Move cursor back one character
Delete character
Move cursor to end of line
Move cursor forward one character
Scroll to next command in command history (use the cli show
history command to display the history)
Scroll to previous command in command history
Erase entire line
Erase from cursor to end of line
Exit current access mode to previous access mode
Starting the Command Line Interface
"Setting Basic System
Command
Software Installation and Setup
for
3-3