Oven Settings - Thermo Scientific SOLA II Flare User Manual

Oven Settings

Parameter
Display Software
Sensor Type
TC Linearization
RTD Leads
Units
Scale Low
Scale High
Range Low
Range High
Process Error Enable
Process Error Low Value
Filter
Input Error Latching
Display Precision
Thermo Scientific
The default settings for the pyrolyzer are provided in the tables on the following
pages.
Table A–17. Oven settings: Setup Page > Analog Input 1
Default
Display Software
RTD 100 Ohm
S
2
Process
0.00
20.00
-18.0°C
5537.0°C
Off
0.00
0.5
Off
Tenths
SOLA II Flare User Manual
Appendix A
Watlow EZ Zone PM6 Series
Comment
For Type S thermocouple
The number of leads on the RTD wired
to this input.
The type of units measured by the
sensor.
The low scale for process inputs.
The high scale for process inputs.
The output low range.
The output high range.
For smoothing the process signal.
A-10