Thermo Scientific SOLA II Flare User Manual page 110

Parameter
Display Software
Display Units
AC Line Frequency
Communications LED Action
Zone
Channel
Display Pairs
Display Time
User Settings Save
User Settings Restore
Parameter
Display Software
Analog Input Value
Input Error
Calibration Offset
Thermo Scientific
Table A–8. Pyrolyzer settings: Setup Page > Global1
Default
Display
Table A–9. Pyrolyzer settings: Operations Page > Analog Input 1
Description
The process value (°C).
The cause of the most recent error. Possible displays listed below.
The offset applied to the input reading to compensate factors that cause the input reading to
vary from the actual process value (°C).
Default = 0.
Software
C
60 Hz
Both
Off
On
1
0
None
None
None
Open
Fail
Shorted
Measurement Error
Bad Calibration Data
Ambient Error
RTD Error
Not Sourced
SOLA II Flare User Manual
Appendix A
Watlow EZ Zone PM6 Series
Comment
Display units are in °C.
The frequency to the applied AC line
power source.
Both comm port 1 and 2 selected.
The Channel LED is on.
The number of display pairs.
The time delay for toggling between
channel 1 and channel 2.
A-6