Chapter 4: Operation; The Interface; Begin Analyzing - Thermo Scientific SOLA II Flare User Manual

The Interface

Begin Analyzing

Thermo Scientific

Chapter 4: Operation

The analyzer utilizes a 4-line by 20-character, vacuum fluorescent display and
four push buttons as the user interface. All programming and adjustments are
accomplished using the push buttons. Following is an example of how to use
the interface to enter the passcode. For information on programming the
passcode, Analyzer Setup.
1. Press any button, and you are prompted to enter the passcode.
2. Press the button below Ent (Enter).
3. To increase the first digit's value press the button below the up arrow
(). Decrease the value by pressing the button below the down arrow
(). When the correct number is displayed, press the button below the
right arrow (>) to enter the next digit.
4. Repeat the process used to enter the first digit for the remaining digits.
5. Once the passcode is complete, press the button below Done.
You can access all program features and edit parameters by following these
steps.
Note For instructions on programming the passcode, see
E n t e r
0 0 0 0

Modify digits
Figure 4-1.
1. If the analyzer is shut down, start up the instrument by following the
appropriate set of instructions in
2. If the system power is off, open the instrument and carrier air flows to
the analyzer, and adjust the pressures to the appropriate settings (refer
to application data that shipped with the analyzer).
P a s s c o d e
 
Advance cursor
Chapter
Setup. ▲
Analyzer
D o n e
3.
SOLA II Flare User Manual 4-1