Software Configuration; Pyrolyzer Settings - Thermo Scientific SOLA II Flare User Manual

Software
Configuration

Pyrolyzer Settings

Parameter
Display Software
Sensor Type
TC Linearization
Filter
Input Error Latching
Display Precision
Thermo Scientific
There are two ways to configure the EZ-ZONE PM6. You can use the menu
system built into the controller and configure it using the display and
appropriate keys to navigate through the system, or alternatively, you can use
the EZ-ZONE Configurator software. Instructions for both methods of
configuration are provided in the EZ-ZONE PM PID Controller user's
manual.
The built-in menu system and configuration software have the following main
pages.
Setup page: Used to set up a control prior to operation.
•
Operations page: Used to monitor or change runtime settings.
•
Factory Page: Used to enable password protection, create a custom
•
Home Page, and perform other tasks that do not have an effect on the
control when running.
Home Page: The page that is displayed when the control is initially
•
powered up.
Parameters for the EZ-ZONE PM6 are set to the optimum values for your
application at the factory. The defaults settings are provided here in the event
the configuration is changed without authorization.
Caution Changing the parameters may adversely affect system performance. ▲
The default settings for the pyrolyzer are provided in the tables on the following
pages.
Table A–2. Pyrolyzer settings: Setup Page > Analog Input 1
Default
Display Software
Thermocouple
S
0.5
Off
Whole
SOLA II Flare User Manual
Appendix A
Watlow EZ Zone PM6 Series
Comment
For Type S thermocouple
For smoothing the process signal.
A-3