2.4
Meter Security
After the node address is set, the instrument will be added to the network of instruments on PanaView and the
operator will be given the opportunity to program the flowmeter parameters. Before any meter parameters can be
changed, the operator must be specified.
Click the mouse right button and then click on
the Security Form. Access the required security level by typing the User Name and Password dialog boxes (see
Figure 33 below).
The meter provides three security levels:
• Level 1 security is available to Panametrics service engineers only. It gives access to configuration parameters
that should be adjusted only during commissioning or repair.
• Level 2 security is for the supervisor who has overall responsibility for the meter. The supervisor may change his
or her password and the passwords of the three user's accounts. The default User Name and Password are:
User Name: Supervisor
Password: [The assigned Serial Number]
Sentinel™ User's Manual
Properties.
Press the Security button on the Properties Form to bring up
Figure 9: Security Form
Chapter 2. Initial Setup
49
Need help?
Do you have a question about the Sentinel and is the answer not in the manual?