3.12.1
Preparing the Electronics
1.
Power down the electronics.
2.
Break the lead and wire seal on the front cover, if one was applied for security reasons (see Figure 64 below).
3.
Unscrew the cover and set it aside.
4.
Identify the notch toward the top left side of the LCD display board, through which the DIP switch can be seen
(see Figure 65 below).
Sentinel™ User's Manual
Figure 23: Breaking the Seal
Figure 24: Locating the Dip Switch
Chapter 3. Operation
85
Need help?
Do you have a question about the Sentinel and is the answer not in the manual?