Panametrics Sentinel User Manual page 72

Chapter 3. Operation
1.
Under the Recorder Properties
2. A window similar to Figure 51 below should appear, asking if you want to test the Recorder. Press
3.
The screen should now look similar to Figure 52 below. Click on the
4. Read the current off the digital multimeter and enter the value from the DMM into the
20 mA
5. Click on the option in the
20 mA
for .
Apply button
6.
Click on the
Note: If you need to calibrate a second time, press the
7. Press OK when you are finished calibrating the analog output.
72
General
tab, click on
Figure 10: Test Recorder Prompt
Trim
section and enter the value from the DMM into the
. You may now select among the test percentages to verify
Figure 11: Test/Calibrate Recorder
Test
.
4 mA
option in the
Reset button.
Yes .
Trim
section.
Actual mA box for 4 mA
Actual
mA box
mA at each percentage.
Sentinel™ User's Manual
.