Panametrics Sentinel User Manual page 47

Table of Contents

Advertisement

Adding the Sentinel to the Communications Port (cont.)
If the node ID is not known, select "
OK
button (see Figure 30 below).
Note:
The network referred to in Figure 2-6 below is the RS485 connection between the instrument and the
computer RS232-to-RS485 connector.
Note:
The new meter must be the only powered meter on the network.
At the next prompt (see Figure 31 below) select "
OK
click on
.
Sentinel™ User's Manual
I don't know the node ID of the meter I am adding to the network
Figure 6: Instrument Node ID Unknown
It is the only meter connected to the communication port
Figure 7: Searching the Port for Instrument Node ID
Chapter 2. Initial Setup
" and then click on the
" and then
47

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Sentinel and is the answer not in the manual?

Table of Contents